Pendulum CNT-90 Series Programmer's Handbook

The *RST Command
Use this command to reset a device. It
initializes the device-specific functions in
the Counter.
The following happens when you use the
*RST command:
–
You set the Counter-specific functions to a
known default state. The *RST condition
for each command is given in the com
-
mand reference chapters.
–
You disable macros.
–
You set the counter in an idle state (outputs
are disabled), so that it can start new oper
-
ations.
The *CLS Command
Use this command to clear the status data
structures. See ‘Status Reporting system’
in this chapter.
The following happens when you use the
*CLS command:
–
The instrument clears all event registers
summarized in the status byte register.
–
It empties all queues, which are summa
-
rized in the status byte register, except the
output queue, which is summarized in the
MAV bit.
3-20 Initialization and Resetting
Introduction to SCPI

Pendulum CNT-90 Series Specifications

General

Brand	Pendulum
Model	CNT-90 Series
Category	Measuring Instruments
Language	English