Calibration menu 02
Add/Replace:
If the indicator must be calibrated for the first time, its needed to delete the old calibration
points first. To delete the points, press the “Delete” button.
When all points are deleted, first calibrate the Dead load (0).
Make sure the scale is completely empty and type 0 in the “Add/Replace” field by pressing the
“Edit” button.
To save the zero point press the “+ Activate” button.
The Dead load is calibrated now and in the weight and weight x 10 field will appear the actual
value.
To make sure the
indicator works all right, its needed to calibrate the “Gain” weight.
The Gain is the reference of the indicator to make the weigher signal a straight line.
To calibrate the gain weight put a reference weight on the scale.
It doesn't matter what mass it is, as long as it’s known what the exact weight is.
Press the “Edit” button to type the exact reference weight in the “Add/Replace” field.
To save the reference weight, press the “ + activate button”.
The reference weight is calibrated now and in the
reference weight.
weight and weight x 10 field will appear the
actual
If more points are needed or need to be added later, repeat the gain calibration with an other
reference weight.
Points:
To add or replace new calibration points, press the “ Add/Replace” button.
The first 4 fields will show the Weigher status (for explanation, see paragraph “show”)
To Next Page
Loading...
Need help?
General
