Output:
The Output value will be provided by the supplier of the loadcells.
Transducers:
In this menu its possible to make a calibration with the information provided with new
loadcells. So its not needed to calibrate the weiger with real weights.
Calibration menu 04
Its possible to set up a maximum of load cells.To setup the used load cells choose
Transducer 1, 2, 3 or 4.
Zero Balance:
The Zero Balance value will be provided by the supplier of the loadcells.
Type:
In this field the type of the loadcells can be editted.
Max Load:
The Max load value will be provided by the supplier of the loadcells.
When this function is used, normal calibration is disabled.
To Next Page
Loading...
