PENKO FLEX2100 User Manual

FLEX 2100
2
IMPORTANT SAFETY INFORMATION
READ THIS PAGE FIRST!
PENKO Engineering B.V. manufactures and
tests its products to meet all applicable
national and international standards. It is vital
that this instrument is correctly installed, used,
and maintained to ensure it continues to
operate to its optimum specification.
The following instructions must be adhered to
and incorporated into your safety program
when installing, using, and maintaining PENKO
products. Failure to follow the recommended
instructions can affect the system’s safety and
may increase the risk of serious personal injury,
property damage, and damage to this
instrument and may invalidate the product’s
warranty.
• Read the instructions fully prior to installing,
operating, or servicing the product. If this
Instruction Manual is not the correct manual
for the PENKO product you are using, call
0031(0)318-525630 for a replacement copy.
Keep this Instruction Manual in a safe place for
future reference.
• If you do not fully understand these
instructions, contact your PENKO
representative for clarification.
• Pay careful attention to all warnings,
cautions, and instructions marked on and
supplied with the product.
• Inform and educate your personnel about
the correct installation, operation, and
maintenance procedures for this product.
• Install your equipment as specified in the
installation instructions of the appropriate
Instruction Manual and as per applicable local
and national codes. Connect all products to
the proper electrical sources.
• To ensure correct performance, use qualified
personnel to install, operate, update, program,
and maintain the product.
• When replacement parts are required,
ensure that qualified technicians use
replacement parts specified by PENKO.
Unauthorized components and procedures can
affect the product's performance and may
affect the continued safe operation of your
processes. The use of non-specified ‘look-alike’
substitution parts may result in the risk of fire,
electrical hazards, or improper operation.
• Ensure that all equipment doors are closed
and protective covers are in place, except
when maintenance is being performed by
qualified persons, to prevent electrical shock
and personal injury.

PENKO FLEX2100 Specifications

General

Brand	PENKO
Model	FLEX2100
Category	Controller
Language	English