FLEX 2100
3
WARNING
ELECTRICAL SHOCK HAZARD
Installing cable connections and servicing this instrument require access to shock hazard level voltages
which can cause death or serious injury.
Disconnect separate or external power sources to relay contacts before commencing any maintenance.
The electrical installation must be carried out in accordance with CE directions and/or any other
applicable national or local codes.
Unused cable conduit entries must be securely sealed by non-flammable blanking plates or blind
grommets to ensure complete enclosure integrity in compliance with personal safety and environmental
protection requirements.
To ensure safety and correct performance this instrument must be connected to a properly grounded,
three-wire power source.
Proper relay use and configuration is the responsibility of the user.
Do not operate this instrument without the front cover being secured. Refer any installation, operation
or servicing issues to qualified personnel.
WWW.PENKO.COM
PENKO Engineering B.V.is an ETC Company
Email: info@PENKO.com
To Next Page
Loading...
