Installer Manual Riversoft - Maintenance
70 / 90 Ref. MKT-IM-045 / A - 13.03.2020
8.5.7.2 Manifold/bypass removal
No. Operation
NOTE
Depending on the installation configuration, the valve may be equipped with a manifold or
a bypass. The following procedure applies to both configuration.
A Remove the softener cover, see 8.5.2. Covers removal (softener and valve), page 63.
B Remove the "U" clips (1) (a screwdriver can be used as a lever if required).
C Remove the manifold/bypass (2) from the valve body (3).
Bypass configuration
Manifold configuration
To Next Page
Loading...
