20
Quick Start
Taking Pictures
¡ Lower the slide lever.
The lens barrier opens.
You hear a confirmation beep, the status lamp blinks red
and green, and the power turns on.
™ Raise the LCD monitor.
£ While looking through the binoculars, turn the central focusing
wheel to adjust the focus.
¢ Press the shutter release button.
You will hear a confirmation beep and the status lamp will glow green for about
one second.
The image will be recorded in the memory.
When the status lamp turns off, you can take the next picture.
When you move the slide lever up and close the lens barrier, the power turns off.
Caution
If the shutter speed is slower than 1/125 second, the status lamp will blink red (camera shake
alarm) after taking the picture. Check the recorded image on the LCD monitor.
Quick Start
Slide lever
To Next Page
Loading...
