peplink ONE One - Page 104


Todefineanewservice,clicktheAddServicebutton,uponwhichthefollowingmenuappears:


ServicesSettings
Enable
Thissettingspecifieswhethertheinboundserviceruletakeseffect.
WhenYesisselected,theinboundserviceruletakeseffect.Iftheinboundtrafficmatchesthe
specifiedIPprotocolandport,actionwillbetakenbythePeplinkBalancebasedontheother
parametersoftherule.
WhenNoisselected,theinboundserviceruledoesnottakeeffect.ThePeplinkBalancewill
disregardtheotherparametersoftherule.
ServiceName
Thissettingidentifiestheservicetothesystemadministrator.Onlyalphanumericandthe
underscore“_”charactersarevalid.
IPProtocol
TheIPProtocolsetting,alongwiththePortsetting,specifiestheprotocoloftheserviceas
TCP,UDP,ICMP,orIP.InboundtrafficthatmatchesthespecifiedIPProtocolandPort(s)will
beforwardedtotheLANhostsspecifiedbytheServerssetting. 
Uponchoosingaprotocol,theProtocolSelectionTooldropdownmenucanbeusedto
automaticallytheportinformationofcommonInternetservices(e.g.HTTP,HTTPS,etc.).
AfterselectinganitemfromtheProtocolSelectionTooldropdownmenu,theprotocoland
theportnumberwillremainmanuallymodifiable.
Port
ThePortsettingspecifiestheport(s)thatcorrespondtotheservice,andcanbeconfiguredto
behaveinoneofthefollowingmanners:
AnyPort,SinglePort,PortRange,PortMap,andRangeMapping

https://www.peplink.com
104
Copyright@2019Peplink
