peplink ONE One - Page 79












EnabledropinmodeusingtheSetupWizard.AfterenablingthisfeatureandselectingtheWANfor
dropinmode,varioussettings,includingtheWAN'sconnectionmethodandIPaddress,willbe
automaticallyupdated.
Whendropinmodeisenabled,theLANandtheWANfordropinmodeportswillbebridged.Traffic
betweentheLANhostsandWANrouterwillbeforwardedbetweenthedevices.Inthiscase,thehostson
bothsideswillnotnoticeanyIPorMACaddresschanges.
AftersuccessfullysettingupthePeplinkBalanceaspartofthenetworkusingdropinmode,itwill,
dependingonmodel,supportoneormoreWANconnections.SomeMediaFastunitsalsosupport
multipleWANconnectionsafteractivatingdropinmode,thoughaSpeedFusionlicensemayberequired
toactivatemorethanoneWANport.

PleasenotetheDropInModeismutuallyexclusivewithVLAN.


https://www.peplink.com
79
Copyright@2019Peplink
