peplink ONE One - Page 98



Therearetwopersistentmodes:BySourceandByDestination. 
BySource:
The same WAN connection will be used for traffic matching the rule and            
originating from the same machine, regardless of its destination. This option          
willprovidethehighestlevelofapplicationcompatibility.
ByDestination:
The same WAN connection will be used for traffic matching the rule,           
originating from the same machine, and going to the same destination. This           
option can better distribute loads to WAN connections when there are only a            
fewclientmachines.
ThedefaultmodeisBySource.Whentherearemultipleclientrequests,theycanbedistributed
(persistently)toWANconnectionswithaweight.IfyouchooseAutoinLoadDistribution,theweights
willbeautomaticallyadjustedaccordingtoeachWAN’sDownstreamBandwidthwhichisspecifiedin
theWANsettingspage).IfyouchooseCustom,youcancustomizetheweightofeachWANmanuallyby
usingthesliders.
Algorithm:Enforced
ThissettingspecifiestheWANconnectionusagetobeappliedonthespecifiedIPprotocolandport.This
settingisapplicableonlywhenAlgorithmissettoEnforced.

MatchingtrafficwillberoutedthroughthespecifiedWANconnection,regardlessofthehealthcheck
statusoftheWANconnection.Outboundtrafficcanbealsobeenforcedtogothroughaspecified
SpeedFusion
TM
connection.
Algorithm:Priority
ThissettingspecifiesthepriorityoftheWANconnectionsusedtoroutethespecifiednetworkservice.The
highestpriorityWANconnectionavailablewillalwaysbeusedforroutingthespecifiedtypeoftraffic.A
lowerpriorityWANconnectionwillbeusedonlywhenallhigherpriorityconnectionshavebecome
unavailable.

https://www.peplink.com
98
Copyright@2019Peplink
