read-only user feature will be enabled.
This field allows you to verify and confirm the new user password.
This field specifies the number of hours and minutes that a web session can remain idle
before the Pepwave router terminates its access to the web admin interface. By default, it
is set to 4 hours.
With this box is checked, the web admin will authenticate using an external RADIUS
server. Authenticated users are treated as either "admin" with full read-write permission
or “user” with read-only access. Local admin and user accounts will be disabled. When
the device is not able to communicate with the external RADIUS server, local accounts
will be enabled again for emergency access. Additional authentication options will be
available once this box is checked.
This specifies the authentication protocol used. Available options are MS-CHAP v2 and
PAP.
This specifies the access address and port of the external RADIUS server.
This field is for entering the secret key for accessing the RADIUS server.
This option specifies the time value for authentication timeout.
This specifies the access address and port of the external accounting server.
This field is for entering the secret key for accessing the accounting server.
This option is for specifying the network connection to be used for authentication. Users
can choose from LAN, WAN, and VPN connections.
The CLI (command line interface) can be accessed via SSH. This field enables CLI
support. For additional information regarding CLI, please refer to Section 21.16.
This field determines the port on which clients can access CLI SSH.
This menu allows you to choose between granting access to LAN and WAN clients, or to
LAN clients only.
This option is for specifying the protocol(s) through which the web admin interface can be
accessed:
● HTTP
● HTTPS
● HTTP/HTTPS