Indicate the preferred frequency to use for clients to connect.
Per FCC regulation, the country selection is not available on all models marketed in
the US. All US models are fixed to US channels only.
This option allows you to specify whether 802.11b and/or 802.11g client association
requests will be accepted. Available options are 802.11ng and 802.11na. By default,
802.11ng is selected.
Available options are 20 MHz, 40 MHz, and Auto (20/40 MHz) . Default is Auto (20/40
MHz), which allows both widths to be used simultaneously.
This option allows you to select which 802.11 RF channel will be utilized. Channel 1
(2.412 GHz) is selected by default.
Indicate the time of day at which update automatic channel selection.
This option is for specifying the transmission output power for the Wi-Fi AP. There are
4 relative power levels available – Max, High, Mid, and Low. The actual output power
will be bound by the regulatory limits of the selected country.
Client Signal
Strength
Threshold
This setting determines the maximum strength at which the Wi-Fi AP can broadcast
To Next Page
Loading...
