Pepwave HD2 - Page 87

Web Administration Settings
Enable
Ticking this box enables web admin access for APs located on the WAN.
Web Access
Protocol
Determines whether the web admin portal can be accessed thorugh HTTP or HTTPS
Management
Port
Determines the port at which the management UI can be accessed.
Admin
Username
Determines the username to be used for logging into the web admin portal
Admin
Password
Determines the password for the web admin portal on external AP.
Wi-Fi WAN settings can be configured at Advanced>Wi-Fi Settings (or Advanced>Wi-Fi
WAN or some models).
Wi-Fi WAN Settings
Channel Width
Available options are 20/40 MHz and 20 MHz. Default is 20/40 MHz, which allows both
widths to be used simultaneously.
Bit Rate
This option allows you to select a specific bit rate for data transfer over the device’s
Wi-Fi network. By default, Auto is selected.
Output Power
This option is for specifying the transmission output power for the Wi-Fi AP. There are
4 relative power levels available – Max, High, Mid, and Low. The actual output power
http://www.peplink.com
87
Copyright @ 2017 Pepwave