Controls
16
0 +1
-1 -2
7.03 Pedal
The pedal functions depend on the selected
operating mode, see Chapter 10 Sewing.
In manual sewing:
+ 1 = sewing
0 = neutral position
-1 = raise sewing foot
-2 = cut thread
In programmed sewing:
+ 1 = start sewing cycle
0 = neutral position
-1 = no function
-2 = seam stop.
Fig. 7 - 03
7.04 Photo sensor
The LED 1 in the photo sensor indicates the
following status:
- LED shows green light = indicates
reception
- LED shows green fl ashing light =
adjustment aid / indicates soiling
- LED shows yellow light = indicates ready
status
Button 2 on the photo sensor is used to
adjust the photo sensor, see Chapter
12.11 Adjusting the photo sensor.
Fig. 7 - 04
1
2
To Next Page
Loading...
