Preparation
26
9 Preparation
All regulations and instructions in this Instruction Manual are to be observed!
Special attention is to be paid to the safety regulations!
All preparation work is only to be carried out by appropriately trained personnel.
Before all preparation work, the machine is to be separated from the electricity
supply by removing the plug from the mains or switching off the On/Off switch!
9.01 Inserting the needle
Switch off the machine!
Danger of injury due to uninten-
tional starting of the machine!
Only use needles from the sys-
tem intended for the machine,
see Chapter 3 Specifi cations.
Raise needle bar.
Loosen screw 1 and insert needle 3 until
you feel it stop.
The long needle groove must be aligned
in the direction of the machine head.
Tighten screw 1.
●
●
●
●
Fig. 9 - 01
1
2
To Next Page
Loading...
Need help?
General
