Controls
20
F1 (cycle time)
If this key is pressed, the display function for the cycle time (duration of a seam
sequence) is switched on or off.
F2 (adjustment aid for the edge trimmer)
If this key is pressed, the corresponding function is switched on or off. If the function is
switched on in the manual sewing mode, the edge trimmer moves to the cutting positi-
on.
F3
After the corresponding "PC" (piece counter) function has been selected, press the key
to reset the piece counter, see Chapter 10.03.03 Switch on edge trimmer with delay
(waistband extension)
Start inhibitor
Press this key to switch the start inhibitor on or off. When the function is switched on,
sewing or the seam sequence cannot be started.
●
●
●
●
To Next Page
Loading...
