Sewing
40
Press the +/- key (A) to select the desired speed (e.g. 2200).
Activate the top line of the display. (LED in the key is illuminated).
Press the +/- key (D) to change the stitch length value (e.g. 2.2 mm).
Sew the fi fth seam section using the pedal function (e.g. 35 stitches).
Call up the corner programming function. (LED in the key is illuminated).
Press the +/- key (S) to select the desired turn (e.g. 23 mm).
Switch on the "turn corner" function for the seam section. The turn is carried out.
Activate the bottom line of the display (LED in the key is not illuminated).
Conclude the "teach in mode". (LED in the key is not illuminated).
The machine starts the thread trimming function and stores the program.
Sew a test seam and, if necessary, make corrections to the seam pattern, see Chapter
10.03.02 Altering seam patterns.
By switching on functions such as "start backtacks/end backtacks", "edge
trimmer", "thread trimmer" etc., these can be assigned to the corresponding
seam pattern.
●
●
●
●
●
●
●
●
●
●
To Next Page
Loading...
Need help?
General
