Pfaff 5483 - Clearance between presser foot and needle plate

22
Correct
setting:
Secondary looper thread regulator
The front edge of the secondary looper thread regulator 2 must be about
8.0 mm from the front edge of primary looper thread regulator 3 (Fig.22.0.2).
22.0.2
<s> ®
8 ni ni y
^ £ 5-: ^
22.0.1
22.1 Loosen screw 1 of secondary looper thread regulator 2.
22.2 Adjustthread regulator2 lengthwiseso that Its frontedge is 8.0mm from the
front edge of thread regulator 3.
22.3 In this position, tighten screw 1.
22.4 Check this adjustment (see "Correct setting").
27
From the library of: Superior Sewing Machine & Supply LLC