Input P45 PD2
50
Group
Parameter
Description
User level
Setting range
Set value
7
799* Selected machine class C 1 - 2
2231, 2235, 2545/46 1
2335 2
8
800* Motor rotating direction when looking at V-
belt pulley
1= anti-clockwise, 0 = clockwise
C 0 - 1 1
801 Reversing angle at end of seam B 10 - 212 35
802* Speed reduction main drive
1 = variable,
0 = 1:1
C 0 - 1 1
881 Adaptation of positioning behaviour of
motor to the machine to avoid vibrations
C 10 - 200 100
884 Proportional amplifi cation of speed control
of sewing motor
B 5 - 40
2231, 2235, 2545/46 20
2335 15
885 Integral amplifi cation of speed control of
sewing motor
C 10 - 100 55
886 Proportional amplifi cation of positioning con-
troller (sewing motor)
C 1 - 100 60
887 Differential amplifi cation of positioning con-
troller (sewing motor)
C 20 - 100 60
889 Time for positioning control in [ms],
0 = always
C 0 - 2500 300
890 Proportional amplifi cation of stop brake C 1 - 200 100
897* MINI-motor variant
1 = long, 0 = short
C 0 - 1 1
9 900 Proportional amplifi cation of speed control-
ler during trimming
B 5 - 50 20
* = These parameters remain unchanged when the set parameter values are reset, see
Chapter 10.01.02 Resetting the set parameter values.
To Next Page