Pioneer SC-LX904 - Page 185

185
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Setting Item Default Value Setting Details
Height 1 Left 0.0 dB After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
/ , adjust
the volume of that frequency between "–12.0 dB"
and "+12.0 dB" (in 0.5 dB intervals) with / . To
readjust the overall volume balance with "Trim",
select "Trim" in / , and use / to adjust the
volume.
• If "OVER!" is displayed during adjustment,
the volume of the frequency band or another
frequency band is too high, so reduce the
volume of the frequency bands until the display
disappears.
• "63 Hz" can only be selected when this speaker
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
• If an item cannot be selected even though
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Conguration"
- "Speaker Channels" matches the number of
connected channels.
Setting Item Default Value Setting Details
Height 1 Right 0.0 dB After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
/ , adjust
the volume of that frequency between "–12.0 dB"
and "+12.0 dB" (in 0.5 dB intervals) with / . To
readjust the overall volume balance with "Trim",
select "Trim" in / , and use / to adjust the
volume.
• If "OVER!" is displayed during adjustment,
the volume of the frequency band or another
frequency band is too high, so reduce the
volume of the frequency bands until the display
disappears.
• "63 Hz" can only be selected when this speaker
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
• If an item cannot be selected even though
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Conguration"
- "Speaker Channels" matches the number of
connected channels.