Planmeca ProOne - Configuring Time and Date Display Formats

14 SETTINGS
74 Planmeca ProOne User’s Manual
• Set time and display format
First touch the
Display button to set the X-ray unit so that
the current time will be shown at the bottom of the control
panel display. The
Display button will be highlighted.
You can choose between 12 and 24 hour system for the
time display. Touch the
12H or 24H button to select the
format you wish to use. The selected format will be
highlighted.
Then set the time by touching the arrow buttons in the
Hour and Minute fields.
• Set date and display format
First touch the
Display button to set the X-ray unit so that
the current date will be shown at the bottom of the control
panel display. The
Display button will be highlighted.
The date can be displayed in following formats:
dd.mm.yyyy, mm.dd.yyyy or yyyy.mm.dd. When you
touch the date format button a display will appear where
you can select the format you wish to use.
Then set the date by touching the arrow buttons in the
Day , Month and Year fields.
Accept the new date and time by touching the green
check mark button in the bottom right corner of the
display. To exit the display without saving the changes,
touch the red cross button in the bottom left corner of the
display.