Planmeca Sovereign - Page 54

INSTALLING THE PYLON AND ARMS
50 Planmeca Sovereign
Installation manual
Adjust the pylon attachment plate position as follows, if needed.
Loosen the attachment plate locking screw using a 10 mm Allen key (1).
The sideways position of the pylon attachment plate is adjusted by turning the plate manually
(2).
The pylon position in depth is adjusted with a screw located behind the attachment plate (use
5 mm Allen key). You can reach the screw from behind the lower edge of the plate (3).
After adjustment tighten the locking screw.
S9.eps
1
2
3
3