Planmeca Sovereign - 6 Installing the Cuspidor; Attaching the Cuspidor to the Floor

INSTALLING THE CUSPIDOR
20 Planmeca Sovereign
Installation manual
6 INSTALLING THE CUSPIDOR
6.1 Attaching the cuspidor to the floor
NOTE The cuspidor must be attached to the floor using Sormat SB 8-20 anchors supplied with
the dental unit. Do not use any other anchors. Follow the anchor manufacturer’s instruc-
tions on how to attachment the anchors.
CAUTION The cuspidor assembly is heavy and must be moved with appropriate trans-
port device. Special care and caution must be exercised during cuspidor
installation.
Unpack the cuspidor from its package.
Slide the dental unit carefully to the rear by pulling from the handle. Carefully let the unit
wheels touch the floor and wheel the dental unit near the installation place.
The base cover attachment mechanism is located inside the cuspidor. Rotate the mechanism
screw using a 6 mm Allen key to move the mechanism arm and to release the cover
attachment (1). Pull the cover away from its position (2).
S71_1.eps
2
1