Plockmatic TR5010e - Trim Knife Motor M2

TR-3-16
4 August 2009
3.2.6 TRIM KNIFE MOTOR M2
AREA C
Removal
1. Remove Rear cover (
3.1.1).
2. Remove connector [E] (
x1).
3. Remove circlip [C] using a circlip plier.
4. Loosen screws [A] holding the motor (
x3).
5. Remove sprocket [F].
6. Remove screws [A] holding the motor (
x3).
Replacement
1. Ifitisdifculttomountsprocket[F]removemasterlink[B].
2. Reverse the removal procedure.
3. Tension the chain so there is no slack when tightening screws [A] (
x3).
[B]
[A] [C]
[E]
[F]
WARNING
Place the safety block [D] between lower knife and upper knife beam. When
removing the chain nothing holds upper knife beam and knife in position.
[D]