Plockmatic TR5010e - Troubleshooting; Fault Code Descriptions and Solutions

Trouble-
shooting
TR-4-1
28 May 2009
4. TROUBLESHOOTING
4.1 FAULT CODE DESCRIPTIONS
Fault Item Fault description Page
code No. No.
TR-001 TR-M1 Transport motor No displacement pulses ........................................ TR-4-2
TR-002 TR-M1/M2 Transport motor and Trim knife motor Cycle time out .................... TR-4-3
TR-003 TR-M1 Transport motor Short circuit ............................................................ TR-4-4
TR-004 TR-M1 Transport motor Open circuit ............................................................ TR-4-4
TR-005 TR-M2 Trim knife motor Short circuit ........................................................... TR-4-4
TR-006 TR-M2 Trim knife motor Open circuit ............................................................ TR-4-5
TR-007 TR-M3 Stop gate motor Cycle time out ......................................................... TR-4-5
TR-008 TR-M3 Stop gate motor Short circuit ............................................................ TR-4-6
TR-009 TR-M3 Stop gate motor Open circuit ............................................................ TR-4-6
TR-010 TR-M4 Stop gate positioning motor No displacement pulses .................... TR-4-6
TR-011 TR-M4 Stop gate positioning motor Cycle time out .................................... TR-4-7
TR-012 TR-M4 Stop gate positioning motor Short circuit ........................................ TR-4-7
TR-013 TR-M4 Stop gate positioning motor Open circuit ........................................ TR-4-8
TR-014 TR-M5/M6 Blower motor(s) Open circuit ............................................................ TR-4-8
TR-015 TR-Q13 Infeed sensor is Faulty ....................................................................... TR-4-8
TR-016 TR-S2/S3 Control switch infeed or out feed Faulty .......................................... TR-4-9
TR-017 TR-Q6 Outfeed sensor Trimmer is Faulty ..................................................... TR-4-9
TR-018 TR-Q8 Trim bin full sensor is Faulty ........................................................... TR-4-10
TR-150 36V Input low .................................................................................... TR-4-10
TR-151 36V Input high ................................................................................... TR-4-10
TR-152 TR-S9/S10 Interlock switch faulty .......................................................................TR-4-11
TR-201 TR-Q13 Infeed sensor was Not blocked within timeout ...............................TR-4-11
TR-202 TR-Q13 Infeed sensor was Blocked exceeding timeout ..............................TR-4-11
TR-203 TR-Q6 Outfeed sensor Trimmer was Not blocked within timeout ........... TR-4-12
TR-204 TR-Q6 Outfeed sensor Trimmer was Blocked exceeding timeout ........... TR-4-12
TR-205 TR-S2/S3 Infeed shaft or Outfeed compressing bracket
not in lower position ......................................................................... TR-4-12
TR-401 Trim bin full ....................................................................................... TR-4-12
TR-501 Trim bin full ....................................................................................... TR-4-12
TR-502 Trimmer fan missing ......................................................................... TR-4-13
TR-503 TR-Q6 Stacker full ........................................................................................ TR-4-13
FAULT CODE DESCRIPTIONS