Pogo Automatic - Replacing the Batteries; Battery Life and Replacement Procedure

Remove Batteries
71
Customer Support 1-855-IMI-POGO (464-7646) • www.presspogo.com
Replacing the Batteries
Your POGO Automatic Meter comes with
two AAA batteries provided at the bottom
of the meter box. The batteries should last
for approximately 500 tests. When the
battery power runs low, the low battery
symbol appears in the status bar. When
this occurs, the meter has enough power
for about 50 tests. Accuracy will not be
aected. However, you should change your
batteries as soon as possible.
Removing the batteries will not aect
the meter memory or previously stored
settings. The time and date will be restored
to the last time and date displayed before
battery removal.
IMPORTANT: When the dead battery symbol appears, your POGO
Automatic Meter will not perform a test. Change the batteries immediately.
• Remove battery door on back of meter
by sliding the door toward the top end
of the meter.
• Remove and discard the used alkaline
batteries according to your local
environmental regulations.
• Install two new AAA batteries side-by-
side into the battery compartment. Be
sure to align the positive and negative
ends as labeled inside the compartment.
Re-insert Batteries
Low Battery
Dead Battery
CARING
FOR
YOUR
POGO
AUTOMATIC