Pogo Automatic - Handling Errors and Alerts; Common Error Codes Explained; Resolving Errors and Alerts

2:15 PM
5/1/2020
9
E-4
2:15 PM
5/1/2020
9
NO
40
Customer Support 1-855-IMI-POGO (464-7646) • www.presspogo.com
If Errors or Alerts Appear
Instead of Result
• If you get an E-4 or NO message,
POGO Automatic did not have enough
blood to complete your test. YOU
SHOULD increase blood ow to your
ngertip and make sure to apply
consistent pressure during automated
lancing (See Helpful Hints on page 30).
• You must start a new test. Turn the meter
o and back on to try again.
Remove le over debris
from test platform before
next test
• While adding more blood, you might get
some on the test port or test platform.
If this occurs, remove blood before
beginning another test. (See Cleaning
and Disinfecting on page 64).
• Blood le over from a previous test is a
biohazard.
• When enough blood has been collected,
you will hear a beep and see
on the meter display. This
indicates your test is complete.
TEST
YOUR
BLOOD