11
9929422 R02 - 2017-2019 ACE 900 Service Manual
© Copyright Polaris Industries Inc.
11.45
HEADLIGHT HOUSING REMOVAL
1. Disconnect the wire harness from the headlamp bulb.
Be sure to pull on the connector, not on the wiring.
2. Remove the O-rings (A) from the headlamp brackets
on both sides of the headlamp.
3. Remove the adjustment screw
q
from the bracket.
4. Carefully remove the headlamp from the front
bumper.
HEADLIGHT HOUSING INSTALLATION
1. Install the headlamp housing back into the front
bumper.
2. Secure the headlamp housing with the rubber Orings
(A) on both sides of the headlamp and install the
adjustment screw (B).
3. Reconnect wire harness or re-insert bulb if previously
removed.
4. Adjust headlights using the “Headlight Adjustment”
procedure in this section.
TAILLIGHT REPLACEMENT
NOTE
Taillight is non-servicable. Must be replaced as an
assembly.
Before replacing the taillight(s), use a digital multi-meter
to test the harness to ensure the lamp is receiving 12
volts and that a ground path is present.
1. Disconnect the wire harness
q
.
2. While holding the taillight assembly, remove the three
nuts
w
retaining the taillight assembly and remove it
from the rear fascia.
ELECTRICAL
To Next Page
Loading...
Need help?
General
