2
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.
2.43
2. Coat the terminals with dielectric grease.
3. Connect and tighten the red (+)
q
cable first.
4. Connect and tighten the black (-)
w
cable last.
5. Verify that cables are properly routed and reinstall the
driver’s seat.
ENGINE / CHASSIS ELECTRICAL GROUND
Inspect the ground cable connections. Remove ground
terminals and clean if necessary.
1. The chassis ground connection
w
, located below the
start solenoid
q
, can be accessed through the left
rear wheel area.
2. Inspect the chassis ground terminals. Be sure the
grounds are clean and tight.
SPARK PLUG SERVICE
WARNING
A hot engine can cause serious burns. Allow engine to
cool or wear protective gloves when removing the spark
plugs.
Inspect and replace the spark plugs at the intervals
outlined in the Periodic Maintenance Chart.
1. Lift the cargo box.
2. Remove both spark plug caps
w
.
NOTICE
Note MAG and PTO reference decals on spark plug
wires for reassembly.
3. Clean out plug wells with compressed air to remove
any loose dirt or debris.
4. Rinse plug wells with water and dry with compressed
air.
NOTICE
Spark plug wells have drain holes built into the cylinder
head to allow water to drain out.
5. Remove spark plugs using spark plug socket with an
extension.
MAINTENANCE
To Next Page
Loading...
Need help?
General
