Polaris GENERAL 2016 User Manual

7.32
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.
6. Remove the fasteners
r
securing the rear bearing
carrier to the upper and lower control arms.
7. With a short, sharp jerk, remove drive shaft from the
transmission splines.
REAR DRIVE SHAFT INSTALLATION
1. Install NEW spring ring on drive shaft. Apply an anti-
seize compound to the splines.
IMPORTANT
2019 General Models have an O-ring
A
on the drive
shaft. Ensure the O-ring is present and not damaged
before installation.
2. Align splines of drive shaft with transmission splines
and reinstall the drive shaft. Use a rubber mallet to
tap on the outboard end of the drive shaft if
necessary.
FINAL DRIVE

Polaris GENERAL 2016 Specifications

General

Brand	Polaris
Model	GENERAL 2016
Category	Offroad Vehicle
Language	English