7
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
7.7
6. CAUTION: Do not hang the caliper by the brake line.
Use wire to hang caliper to prevent damage to the
brake line.
7. Remove the rear wheel hub assembly.
8. Remove the bolts, nuts and washers that attach the
rear bearing carrier to the upper and lower A-arms.
Discard nuts and replace with new.
9. Remove the bearing carrier from the rear drive shaft.
10. Rotate bearing by hand and check for smooth
rotation. Visually inspect bearing for moisture, dirt, or
corrosion.
NOTE
Due to extremely close tolerances and minimal wear,
the bearings must be inspected visually, and by feel.
While rotating bearings by hand, inspect for rough
spots, discoloration, or corrosion. The bearings should
turn smoothly and quietly, with no detectable up and
down movement and minimal movement sideways
between inner and outer race.
11. Replace bearing if moisture, dirt, corrosion, or
roughness is evident.
FINAL DRIVE
To Next Page
Loading...
Need help?
General
