Polaris RZR 570 2015 Service Manual

2.18
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
COOLING SYSTEM
1. Inspect all hoses for cracks, deterioration, abrasion
or leaks. Replace if necessary.
CAUTION
Do not over-tighten hose clamps at radiator, or radiator
fitting may distort, causing a restriction to coolant flow.
TORQUE
Radiator Hose Clamps:
36 in-lb (4 Nm)
2. Check tightness of all hose clamps.
COOLANT DRAIN
1. Remove the hood from the front cab.
WARNING
Never drain the coolant when the engine and radiator
are warm or hot. Hot coolant can cause severe burns.
Allow engine and radiator to cool.
2. Slowly remove the pressure cap to relieve any
cooling system pressure.
3. Place a suitable drain pan underneath the radiator
fitting on the front right-hand side of the vehicle.
4. Drain the coolant from the radiator by removing the
lower coolant hose
q
from the radiator as shown.
Properly dispose of the coolant.
5. Allow coolant to completely drain.
6. Place a suitable drain pan underneath the lower
engine hose
w
on the right-hand rear side of the
vehicle.
7. Remove the hose and completely drain the engine.
Reinstall the lower coolant hose.
8. Properly dispose of the coolant.
9. Remove the pressure cap. Using a funnel, add the
recommended coolant to the top of the filler neck and
fill the recovery bottle to the MAX level.
10. Refer to Chapter 3 for the “Cooling System Bleeding
Procedure”.
Polaris Premium Antifreeze
2871534 - Quart
2871323 - Gallon
MAINTENANCE

Polaris RZR 570 2015 Specifications

General

Brand	Polaris
Model	RZR 570 2015
Category	Offroad Vehicle
Language	English