Polycom HDX 8000 series User Manual

Polycom, Inc. 10–1
10
Control Devices
Configuring Remote Control Behavior
You can customize the behavior of the remote control to support a user’s
environment.
To configure remote control behavior:
1 Do one of the following:
— In the local interface, go to System > Admin Settings > General
Settings > System Settings > Remote Control/Keypad (select if
necessary).
— In the web interface, go to Admin Settings > General Settings >
System Settings.
Points to Note about remote control behavior:
• If the Polycom HDX system is paired and connected with a Polycom Touch
Control, the remote control is disabled.
• Polycom HDX 8000 series, Polycom HDX 7000 series, and Polycom HDX 6000
series systems must be connected to a camera with an IR receiver to receive
signals from the remote control. Be sure to point the remote control at the
camera to control those Polycom HDX systems. Refer to the “Interoperability”
section of the current HDX system release notes for a list of supported cameras
with IR receivers.
• The Polycom HDX remote control IR transmits a modulated frequency of
38 kHz.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Polycom HDX 8000 series Specifications

General

Microphone	Polycom HDX Microphone Array
Network Protocols	H.323, SIP
Network Interface	10/100/1000 Ethernet
Network Interfaces	10/100/1000 Ethernet
Video Standards	H.263, H.264
Video Resolution	720p, 1080p
Content Sharing	H.239, People+Content
Audio Standards	G.711, G.722, G.728, G.729A
Encryption	H.235 (AES)
Camera	Polycom EagleEye HD camera
Data Standards	H.239
Video Inputs	HDMI, DVI-I
Video Outputs	HDMI, DVI-I
Audio Inputs	3.5mm stereo line-in
Audio Outputs	RCA
Display Outputs	HDMI, DVI-I