EasyManua.ls Logo

Polycom SoundStructure C12 - Page 505

Polycom SoundStructure C12
712 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Specifications
15 - 3
System
• Frequency response: 20-22,000 Hz, + 0.1 /- 0.3 dB
• Idle channel noise: <-109 dB FS no weighting, 20-20,000 Hz, -60 dB FS, 997
Hz input signal, 0 dB gain
• Dynamic range: >109 dB FS no weighting, 20 - 20,000 Hz, -60 dB FS, 997
Hz input signal, 0 dB gain
• Linearity: 0 dB FS to -122 dB FS +/- 1 dB
• THD+N: < 0.005%, -20 dB FS input signal
• Common mode rejection ratio: <-61 dB, 20-20,000 Hz, no weighting
• Cross talk: <-110 dB, 20-20,000 Hz, 1 kHz, channel-to-channel
• Latency: Mic/Line inputs to outputs: 23 ms, AEC and NC processing
enabled
• Acoustic echo cancellation span: 260 ms
• Total cancellation: >65 dB
• Convergence rate: 40 dB/second
• Noise cancellation: 0-20 dB, software selectable
• Control inputs: contact closure
• Status outputs: open collector 60 V and 500 mA maximum total per
outputs
• All signal ground pins connected to chassis ground through low
impedance planes
Telco
• Input gain: -100 to +20 dB in 1 dB steps, software adjustable
• Nominal transmit level: 0 dBu in SoundStructure device yields -15 to -17
dBm to phone (country code dependent)
• Off hook loop current: 10 mA (minimum) to 120 mA (maximum)
• Output gain: -100 to +20 dB in 1 dB steps, software adjustable
• Frequency response: 250-3300 Hz
• Dynamic range: >70 dB FS, 250-3300 Hz, "A" weighted
Unless noted, all values are valid for all channels at 0 dB input gain.

Table of Contents