PoolPak MPK series - Features and Options; Standard Factory Mounted Features; Standard Factory Supplied, Field Installed Features; Optional Factory Mounted Features

www.poolpak.com | 800-959-772520 | MPK Series - Installation, Operation and Maintenance
Features and Options
Standard Factory Mounted Features
• Direct drive plenum fans
• Variable frequency drives or EC motors
• Two inch, double wall, foam insulated panels
• Airflow monitoring (transducers located on fans and outside air)
• Evaporator coil (heat recovery coil)
• Air reheat condenser coil
• Pool water condenser coil
• Compressor performance monitoring: suction and discharge pressure transducers
• Supply air configuration: all sides available.
• Dampers: outside air, recirculation air, evaporator bypass air
• Gravity relief dampers on exhaust and purge (SE/SEP)
• Temperature (T) and relative humidity (H) sensors:
• Return air, T and H
• Air of the evaporator, T and H
• Supply air, T
• Pool water, T
• Compressor suction temperature, T
• Filters and filter rack (return and outside air)
• Remote monitoring via internet
• Dirty filter indicator
• Network multiple units – connect up to 5 units
• Weatherproofing for outdoor installation
Standard Factory Supplied, Field Installed Features
• Temperature (T) and relative humidity (H) Sensors:
• Cold surface temperature sensor, T
• Outside air, T and H
• Pool water, T (only if Smart Pump Control option is selected)
• Remote Interface Unit (RIU)
Optional Factory Mounted Features
• Integral hot water coil and valve
• Integral auxiliary heat module (gas furnace or electric heat)
• Integral air cooled condenser and associated refrigerant piping
• Integral chilled water coil and valve
• Remote exhaust fan control
• Building automation system connection (LonWorks, Modbus, or BACnet)
• Freeze protection
• Smart Pump Control