PoolPak MPK series - Curb Mounting

To Next Page

To Previous Page

PoolPak

MPK Series IOM

If the factory is not notified that a PoolPak is to be curb mounted, the PoolPak base

will not be watertight, it will leak, and it will not be properly insulated.

NOTE

Curb Mounting

Curbs have been designed specifically for the PoolPak® product line. Contact factory for roof curb dimensions. The

outside dimensions of the curb are such that the base of the PoolPak® overhangs the edge of the curb on each side.

This aids in preventing rain water, running down the sides of the unit, from getting between the base of the PoolPak

and the curb.

It is the installing contractor’s responsibility to properly complete the following:

• Flash the curb into the roof

• Insulate the curb

• Connect the supply and return ducts to the PoolPak

• Connect condensate drain lines with appropriate traps

• Seal the curb top surface to the bottom of the PoolPak with supplied gasket

If specified when ordering, all water piping connections can be made through the curb. These water connections

include:

• Pool water

• Condensate

• Auxiliary hot water coil

• Chilled water coil

If the PoolPak is to be mounted on another manufacturer’s curb, the PoolPak factory must be notified of this at the

time the PoolPak sales order is submitted. PoolPak units produced for curb mounting, whether on a PoolPak curb or

on another manufacturer’s curb, receive special weatherizing and insulating that non-curb mounted PoolPak units do

not receive.

Other manuals for PoolPak MPK series