PoolPak MPK series - Page 64

www.poolpak.com | 800-959-772564 | MPK Series - Installation, Operation and Maintenance
Dampers (% Open):
OA – Outside Air RC – Recirculation Air EV – Evaporation Bypass Air
Airflow (kCFM)
S – Supply Air E – Exhaust Air P – Purge Air O – Outside Air
Fan RPM
S – Supply Fan E – Exhaust Fan P – Purge Fan
CMPR MODULE 1 STATUS: No Active Faults or CprFaultName
MODE REQ – CmprMode requested by Controller at time of fault
ACT – Actual CmprMode running at time of fault
AMPS – Compressor Run Amps
CODE – Factory Use Only
DISCH P – Discharge Refrigerant Pressure (psi)
SUCT P – Suction Refrigerant Pressure (psi)
LIQ T – Liquid Refrigerant Temperature (°F)
SUCT T – Suction Refrigerant Temperature (°F)
Fan Currents (Amps) D cabinets only:
S – Supply Fan E – Exhaust Fan P – Purge Fan
System Status – Factory Use Only
Figure 5-20. Fault Screen 2 – Airflow Status
Figure 5-21. Fault Screen 3 – Fan Currents
Figure 5-22. Fault Screen 4 – Compressor Module 1 Fault Screen