POSEIDON Jetstream Service Manual

JETSTREAM
1.0:E12
Removal:
1. Remove the servo valve (14).
2. Unscrew the stop screw (9) and
remove the valve tube (12).
Remove the o-rings (11) (13)
with an o-ring remover. Make
sure the sealing surfaces are not
damaged.
3. Remove the rubber plate (10).
4. Place the valve housing in the
tool. Unscrew the valve housing
(4) with a special spanner.
5. Remove the o-ring (7) with an
oring remover. Make sure the
sealing surfaces are not
damaged.
6. Remove the valve insert.
7. Remove the o-rings (5) (3) with
an o-ring remover. Make sure
the sealing surfaces are not
damaged.
Sealing surfaces

POSEIDON Jetstream Specifications

General

Brand	POSEIDON
Model	Jetstream
Category	Controller
Language	English