1 bit: Timing Supply Water
0 Timing Supply Water function is invalid
1 Timing Supply Water function is valid
10 bit: Pressure given
0 The pressure given during regular pressure water supply is set according PID given value
selecting P03.
1 The pressure given during regular pressure water supply is set according the current
corresponding H47~H54 digital voltage given.
100 bit: Timing mode
0 Cycle mode
Timing the operation time from the starting to the set watter supply time,the inverter will
automatically move to the next period of time set, after the end of a loop, it will
automatically re-start from the first paragraph 0, then cycle to run.
1 Single cycle
Start to time from start running, after it reached the setting time, the inverter will
automatically move to the next period of time set, after the end of a loop, the inverter will
stop and wait for the next running command.
1000 bit: The current regular time
When the water supply time set 0, it means cancel the water supply time setting of this period
Iming shift alternation time control the alternation ways and time of pump.
When Timing Shift Alternation Time is set to 0.0 hour and cancel Timing Shift Alternation
function.
When the Timing Shift Alternation Time between 0.1~3,200 , after corresponding time of
the stable running, in accordance with the principle of first stop for the one first started to control
switch of pump.
First stop for the first pump started: When reduce pumps control, stop the first pump which
To Next Page
Loading...
Need help?
General
