955725_4
22
Metrics: The metrics are all of the buttons that
display planter information on the home screen.
Metrics can be displayed in five different sizes:
Small (1x1), Wide (2x1), Tall (1x2), Large (2x2),
and Extra Large (3x3). Not all metrics are
available in Large and Extra Large. Press the size
buttons on the right hand side of the screen to
view the metrics available in each size.
Note: Definitions for the Metric and Control
buttons can be found in Appendix A –
Understanding the Home Screen Buttons.
Controls: The control buttons are used to control the different systems that can be installed on
the planter. Control buttons can be displayed in three different sizes: Wide (2x1), Tall (1x2), and
Large (2x2). The vDrive/vSet Select and DeltaForce control buttons are set by default on the
Standard and Metrics screens. Other control buttons must be added manually. (i.e. vApplyHD).
Note: The Large control buttons also add quick adjustment features for the control system.
These quick control features can also be accessed by pressing and holding on the smaller control
buttons.
The same control button controls both vDrive and vSet Select. The button itself will switch
modes depending on the drive system configured in the Equipment menu. The vApplyHD and
FlowSense control buttons are the same and will switch according to which system(s) are
configured. Additionally, the name of the vApplyHD and FlowSense control buttons will be
Product 1 and Product 2 by default. Once the liquid system(s) are configured on the monitor, the
name of these control buttons will change to reflect the product Nickname(s) that are set. The
Product 2 control button will only be used if there are two liquid systems installed on the planter.
To Next Page
Loading...
