Precor Experience Series User Manual

Removal Instructions
This procedure will require a fully charged good battery to operate the lift motor.
IMPORTANT: It's important to follow the removal steps in sequence to successfully
remove the ramp.
1. Remove the Lift Front cover (see "Lift Front Cover Replacement" on page72) and Rear
Lift cover (see "Lift Rear Cover Replacement " on page77).
2. Access the service menu diagnostic CrossRamp Test and raise the incline level to 10.
a. P10, P30, P30i and P31: (Service menu (51765761) > MACHINE TEST >
CROSSRAMP TEST and raise the INCLINE LEVEL to 10).
b. P62, P80, and P82: (Service menu (51765761) > System Settings > System
Tests > CrossRamp Test and raise the INCLINE level to 10).
3. Disconnect the Lift Motor input power/control cable connector.
WARNING:Make sure to disconnect the Lift Motor input power/control cable or it is
possible for the crossramp to automatically lower to level 1 under certain cir-
cumstances, such as, if the CrossRamp Test is exited or the console powers down.
This unexpected action could cause personal injury.
4. Remove the left and right Stairarms from the respective input Crank Spindle, see "Stair-
arm Input Crank Removal" on page199. Repeat procedure for the left and right Stair-
arms.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 188
6 Replacement Procedures
Ramp Assembly Replacement

Precor Experience Series Specifications

General

Brand	Precor
Model	Experience Series
Category	Fitness Equipment
Language	English