Precor Experience Series - Page 204

a. . Raise and lower the INCLINE from minimum to maximum range while varying
the Stairarm speed from 50 to > 150 SPM.
b. Repeat this test for several incline cycles.
12. Reinstall the Rear Lift cover (see "Lift Rear Cover Replacement " on page77) and the
Lift Front cover (see "Lift Front Cover Replacement" on page72).
13. Verify machine operation and return to service, see "Standard Service Menus" on
page19.
Note:This procedure may have generated lift motor related error codes. Check the
error log and resolve any active error codes (for LED consoles, clear the error log.
See Also
"Lift Motor Calibration" on page60
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 196
6 Replacement Procedures
Ramp Assembly Replacement