Precor Experience Series - Page 203

7. Reinstall the left and right Stairarms onto the respective Crank Spindle, see "Stairarm
Input Crank Installation" on page203. Repeat procedure for both the left and right Stair-
arms.
8. Reconnect the input power/control cable.
9. Access the service menu diagnostic CrossRamp Test and operate the ramp incline
level through the full range of motion from minimum to maximum range and verify oper-
ation:
l P10, P30, P30i and P31: (Service menu (51765761) > MACHINE TEST >
CROSSRAMP TEST.
l P62, P80, and P82: (Service menu (51765761) > System Settings > System
Tests > CrossRamp Test.
10. Exit the service diagnostic test menu.
11. Select QUICKSTART and start a manual workout. Operate the machine at the fol-
lowing conditions to verify the Stairarm and ramp incline operation. Make sure that the
Stairarms and ramp movement is smooth and that there are no unusual noises:
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 195
6 Replacement Procedures
Ramp Assembly Replacement