12.2.9
‘Date’
‘Menu / Information
è
Settings
è
Date
è
...’
You can set the date in the
‘Date’
menu.
12.3
‘Hose replacement’
‘Menu / Information
è
Service
è
Hose replacement
è
...’
This menu only appears once a manual stop has been performed using
[STOP/START]
.
Here you can replace a hose following the guidance provided. For the
detailed description - see
Ä Chapter 15.1 ‘Replacing pump hose’
on page 86
12.4 Timer
‘Menu / Information
è
Timer
è
...’
–
Please first read this chapter to get an overview.
You will then understand the timer better when
working through the chapter.
The timer DULCO flex Control can do the following at predefined times
and intervals or event-dependent:
n open / close the relays
n switch the level of a Config I/O output
n be triggered by the level at a Config I/O input
n start a delayer
n switch operating mode
n allow the pump to work at a defined capacity
n stop / start the pump
n trigger a batch (
‘Batch (time)’
)
12.4.1 Activation / deactivation
‘Menu / Information
è
Timer
è
Activation
è
...’
You can only program the timer when ‘Activation’ is set
to ‘inactive’ .
To program the timer, set
‘Activation’
to
‘inactive’
.
ð
The first line of the timer menu
‘Timer status’
then shows
‘Inactive’
.
To activate the timer, set
‘Activation’
to
‘active’
.
ð
The first line of the timer menu
‘Timer status’
then displays
‘active’
.
The timer starts working - the timer identifier
is visible in the
continuous display.
Set up /
‘Menu’
60
To Next Page
Loading...
Need help?
General
