The
‘Service’
menu is split into the following sub-menus:
1 -
‘Access protection’
2 -
‘Password’
3 -
‘Clear counters’
4 -
‘Hose’
5 -
‘Error log book’
6 -
‘Display’
7 -
‘Factory setting’
8 -
‘Spare parts kit number’
12.5.1
‘Access protection’
‘Menu / Information
è
Service
è
Access protection
è
...’
You can lock parts of the setting options here.
The following locking options are available:
Selection Point ① Point ②
‘None’
- -
‘ Lock menu’
X -
‘Lock all’
X X
STOPSTOP
STARTSTART
1
Setting
mode
Continuous
display
Stop/start pump
Priming
Start batch (only in "Batch" operating mode)
Acknowledging errors
Check adjustable values
2
Changing directly changeable variables
B0598
Fig. 34
If you have set a
‘Password’
- see below, then the identifier
will appear
after 1 minute in the top left and the specified areas will be locked, if no
key has been pressed in the meantime.
Both locks use the same
‘Password’
.
Set up /
‘Menu’
77
To Next Page
Loading...
