11 Initial commissioning
User qualification: Technical personnel and service - see
Ä ‘Qualification
of personnel’ on page 12
WARNING!
The rotating rotor may catch and trap body parts.
– Only use the pump hose in the dosing head as out‐
lined in the instructions provided below.
The user should only now install the rotor half supplied - this will extend
the bearing service life of the pump hose.
Fig. 29: Starting state of rotor (bearing cover not shown)
1.
If still necessary: Press
[STOP/START]
to bring the pump to a
stop (manually).
2.
Go to
‘Hose replacement’
menu - used here to fit the hose.
ð
‘Go to change position?’
appears.
WARNING!
The rotating rotor may catch and trap body parts.
– Only take off bearing cover once the pump prompts
you to do so.
–
Refit bearing cover once prompted to do so by the
operating instructions.
3. Confirm the question with
‘Yes’
.
ð
The rotor turns slowly and the following appears:
‘ Please wait...’
.
The rotor stops and
‘Please remove cover and take out the
Rotor!’
appears.
Initial commissioning
42
To Next Page
Loading...
