ProMinent DULCO flex Control User Manual

13 Operation
User qualification: Instructed person - see
Ä ‘Qualification of personnel’
on page 12
This chapter describes all the operating options in a continuous display
(several symbols and the pressure display appear at the top in the black
bar) for the trained person at the pump.
– Please also refer to the "Operating/Setting overview"
and "Continuous displays and secondary displays"
overviews at the end of the operating instructions
and also the "Overview of equipment and control
elements" chapter.
13.1 Manual operation
Stop the pump: Press
[STOP/START] .
Start the pump: Press
[STOP/START] again.
Press
[Priming] .
Turn the [Clickwheel] to extend or shorten the priming time during priming.
In ‘Batch’ operating mode: Press the [Clickwheel] in the ‘Push’ contin‐
uous display.
Press the
[Clickwheel] to acknowledge error messages that require
acknowledgement.
In a continuous display: Another continuous display appears each time the
[Clickwheel] engages when turned. (The number depends on the configu‐
ration.)
1. Press the
[Clickwheel] .
ð
The variable can be changed (highlighted).
2. Turn the
[Clickwheel] .
ð
The variable is changed.
3. Press the
[Clickwheel] .
ð
The variable is saved (the highlighting disappears).
If the "lock" - "lock all" has been set - see
Ä ‘Set-up overview DULCO flex
Control’ on page 82
, first enter the ‘Password’ after pressing the
[Clickwheel] .
List of directly changeable variables:
n Capacity
n Contact volume
n Batch dosing time
Stop/start pump
Priming
Starting a batch
Acknowledge errors
Check adjustable variables
Change directly adjustable variables
Changing a variable in the relevant contin‐
uous display:
Operation
81

ProMinent DULCO flex Control Specifications

General

Brand	ProMinent
Model	DULCO flex Control
Category	Water Pump
Language	English