11
Installation and SetupPegasus R4i Product Manual
• Secure the clamp plate on the right side; secure the clamp plate on the left side of the
Pegasus R4i to the bracket post in the enclosure.
• Close the Mac Pro enclosure, connect the power and power on the system. Please refer
to your Mac Pro Essentials Guide for instructions.
When the system is booted up, you can install the Pegasus Utility to use some advanced
features specially created for the Pegasus R4i. See “Installing the Software on Mac Pro”
on the next page. The Pegasus Utility is located on the Pegasus R4i volume.
Clamp plates attach on each side
Pegasus R4i installed in upper MPX bay (without clamp plates)
To Next Page
Loading...