This chapter helps you assemble the chassis and install components.
BeFOre yOu Begin
Pay close attention to the Safety Instructions, Warnings and Cautions in this chapter. Make sure you follow
these steps before attempting to dismantle or remove any part of the server hardware.
1. Make sure the server is powered off.
Power down the server if it is still running.
a. Press the Power button to power off the server from full-power mode to standby- power (sleep) mode.
The Power LED at the front turns from solid green to blinking green.
b. Disconnect the power cord rst from the AC outlet and then from the server. The power LED turns off.
2. Ensure you have a clean and stable working environment. Avoid dust and dirt because contaminants may
cause malfunctions.
3. Ground yourself properly before touching any system component. A discharge of static electricity may
damage components. Wear a grounded wrist strap if available.
WARNING
The server is not completely powered down when you press the
Power button on the front panel. The Power button lets the server
toggle between Power On and Standby (Sleep) modes. Some internal
circuitry remain active in the Standby mode. To remove all power from
the system completely, be sure to disconnect the power cord from the
server.
SySteM Hardware aSSeMbly
25
System Hardware AssemblyVess A6120 Product Manual
To Next Page
Loading...
Need help?
General
