Introduction MP.11-R Installation and Management
Reference Manual
11
• Chapter 4 “Basic Management”: Explains how to navigate the user interface, and discusses the most common
settings used to manage the unit.
• Chapter 5 “System Status”: Depicts the Web Interface’s “Status” options, including System Status and Event Logs.
• Chapter 6 “Configuration”: Depicts the Web Interface’s “Configure” options in a hierarchical manner, so you can
easily find details about each item.
• Chapter 7 “Monitoring”: Depicts the Web Interface’s “Monitor” options in a hierarchical manner, so you can easily
find details about each item
• Chapter 8 “Commands”: Depicts the Web Interface’s “Commands” options in a hierarchical manner, so you can
easily find details about each item
• Chapter 9 “Procedures”: Provides a set of procedures, including TFTP Server Setup, Configuration Backup,
Restore, and Download, Forced Reload, and Reset to Factory Defaults.
• Chapter 10 “Troubleshooting”: Helps you to isolate and solve problems with your radio unit.
The appendixes contain supplementary information you may not need immediately, including Country Code Tables and
Technical Support information.
NOTE: If you are already familiar with this type of product, you can use the Quick Install Guide to install the unit.
Reference Manual
As a companion to the Installation and Management manual, the Tsunami MP.11/QB.11 Reference Manual provides the
following supplemental information:
• Command Line Interface: Documents the text-based configuration utility’s keyboard commands and parameters.
• Event Log Error Messages: Documents the error messages that you may see in your Event Log.
• Alarm Traps: Documents the alarm traps that can be set.
• Microsoft Windows IAS Radius Server Configuration: Provides information to assist you in setting up the IAS
Radius Server.
• Addition of Units to a Routed Network: Describes how to add more units to your routed network.
• Glossary: Describes terms used in the Tsunami MP.11 documentation and in the wireless industry.